Hold the paint scraper at an angle with the edge against the wall and work methodically to move it over the surface to lift the lead paint. If you’re struggling to peel the paint, heat the region gently with a heat gun to soften it. If a heat gun fails, abrasive blasting loosens stubborn old paint. Grab some isopropyl alcohol, also known as rubbing alcohol. Dampen a soft cloth with the alcohol. Gently rub the cloth over the paint stain until it begins to lift. If the cloth gets saturated with paint, use a clean section to continue. Wipe the wood down with a damp rag afterward and let it air dry. All you need to do is to get the dirt off , then remove the old wax with paint thinner. Once this is done apply coats of 1/2 denatured alcohol mixed with 1/2 shellac. The new shellac will melt the original shellac, forming a new beautiful finish. Scratches and white marks will also go away. Ram the claw of your hammer into the nail shank and rock it sideways using the claw edge as a pivot point. Repeat the process until you pry out the nail. This nail-pulling technique produces maximum pulling power with little stress on the handle. Because the hammer claw grabs the nail’s shank, this method usually works even when the nail head Spray sanding sealer on the spindle either with an air gun or an aerosol can. Let it dry, then sand lightly with 220-grit sandpaper. Apply two or three clear finish coats by spraying, sanding each coat lightly with 220 or finer paper after it dries and before applying the next. Don't sand the final coat. . Put on protective gloves, protective eyewear, and a respirator. In a well-ventilated area, apply the stripping gel to the wood surface following the manufacturer's instructions. Rather than coat the entire piece, work on designated sections at a time. Allow the stripping gel to sit for 30 minutes to 24 hours depending on the product's directions. Like toothpaste, you can clean with baking soda to remove water marks from wood. 'Simply make a paste from two parts baking soda to one part water and apply with a microfiber cloth ( you can buy these from Amazon ). Rub the baking soda mix over the water mark gently until it disappears. As always, once the baking soda is removed entirely, add a Try this: Re-sand all the surfaces through 80, 120, 180, and 220 grit, paying special attention to the watermarked areas. This should remove most of the surface stain and knock down any raised fibers. Then, wipe on a generous coating of boiled linseed oil. Allow it to penetrate for 5–10 minutes before wiping it off with a paper towel. In your bucket, add equal volumes of warm water and white vinegar. Using the brush, generously apply the mixture to a portion of the wood. Let it sit for some minutes until the lacquer appears soft and dissolves into the solvent. Using the scraper, scrape off the finish, following the wood grain to prevent damage. Cleaning wood before staining or painting. Removing grease and grime from wood surfaces. Softening old paint for easy removal. Pros of using mineral spirits on wood. Effectiveness in removing finishes and cleaning wood. Low cost and easy availability. It can be used to restore the natural color of the wood.

how to remove finish from wood